Skip to content

Introduction & Preparation

Welcome to the assembly guide for your new 3D printer! Building your own printer is a challenging but incredibly rewarding experience. This guide is here to lead you through every step of the process.

This first chapter is designed to prepare you for the build, introduce you to the tools and parts, and provide some essential tips and warnings for a successful assembly.

Take Your Time and Have Fun

The most important advice we can give is to enjoy the process. Put on some music, work with a friend, and have fun. Rushing the assembly is the most common cause of problems later on.


Your Toolkit

All the basic tools required to build your printer are included in the kit. No extra soldering or wire crimping is required.

  • Included Tools:
    • Needle-nose pliers
    • Screwdriver
    • A set of Allen keys

Included Tools   Included Tools  

The standard tools included with your kit.

Understanding the Kit Parts

To make the assembly process easier, all parts are organized and labeled.

  • Labeled Bags: All boxes and bags containing fasteners and parts are labeled. The number in the header tells you which chapter of the assembly you will need that bag for.
  • 1:1 Scale Cheatsheet: Many of the fastener labels are printed at a 1:1 scale, so you can use them to identify the correct screw or nut by placing it directly on the label.
  • Spare Parts Bag: We've included a special bag with spare fasteners. If you lose a screw or a nut during the build, use one from this bag.

Pro-Tips for a Smooth Assembly

  • Read First, Then Assemble: Always read all the instructions for the current step before you start assembling. Following only the pictures is not enough.
  • Inserting Nuts into Printed Parts: Sometimes, a nut might be a tight fit or might keep falling out of its slot in a printed part. Here's how to handle it:
    • If a nut won't fit: Use a screw from the opposite side of the hole to gently pull the nut into its slot as you tighten it. Remove the screw afterwards.
    • If a nut keeps falling out: Use a small piece of tape to temporarily hold the nut in place. You can remove the tape as soon as the screw has engaged the nut's thread.
  • Use Reasonable Force: The printed parts are tough, but they are not indestructible. If something doesn't seem to fit, double-check that you are using the correct part and following the instructions before applying more force.

CRITICAL: Electronics Protection

Protect Your Electronics from Electrostatic Discharge (ESD)

The electronic components, especially the mainboard, are sensitive to static electricity. A small shock that you might not even feel can permanently damage them. * Keep electronics in their anti-static bags until the very moment you are instructed to install them. * Handle boards by their edges. Avoid touching the chips, capacitors, or other small components on the surface. * Discharge yourself first. Before you touch any electronic component, touch a large, grounded metal object nearby (like a radiator or metal desk leg) to discharge any static electricity from your body. * Be extra cautious on carpets and when wearing fabrics like wool, which can easily build up static electricity.