Wiring Diagram

Controller board¶

In this printer i use the MKS board SGEN_L V2.0, it's a powerful 32-bit 3D printer control board. It has a 120MHZ LPC1769 CPU, integrated SGEN_L V2 hardware 4KB EEPROM, 5 axes and dual Z interface and 12/24V output fan interface, support TMC UART and SPI mode...

For more information about this board you can consult the official page Makerbase as well as the page GitHub.

If you want to buy this board please use my affiliate link, it helps my project a lot - Link to AliExpress

MKS board SGEN_L 01 MKS board SGEN_L 02 MKS board SGEN_L 03

Touch screen display model¶

For display use the MKS H43 is a 4.3 inch high definition IPS screen with a resolution of 800 * 480 and uses a captivating touch screen

You can also find more information about this display on the official page Makerbase as well as the page GitHub.

MKS Display 01 MKS Display 02